This is a video of the 3D print I made of Atlas from Portal 2.

3D Print: Atlas (Part 1)

This is a video of the 3D print I made of Atlas from Portal 2. More information on this can be found on the full post of the project here.  This is just for what I'm calling "Part 1" of this project.  The second part will be where I connect Atlas up to a permanent base that will also be custom made.

3D Print: Atlas (Part 2)

The follow up to part 1, where I finally finished the custom base. The custom base was a 3D printed Portal button, that housed it's own circuit to illuminate some LEDs and Atlas's circuit was also connected to this one so everything ran off 1 USB power cable.

The video I made below was fairly different from the ones I've made so far. Starting with the Claptrap videos I did a few months ago, I've been trying to up my quality a bit and put more effort into the presentation of the videos I've been making. The video doesn't have much commentary apart from the initial introduction, but I did try to present the photos and embedded video content in a nice format :) The video was created using After Effects.

More information on this can be found on the full post of the project here.